DESCRIPTION

Wood panel E0 MRMDF, faced with decorative CLPL® on both sides.

FACE

Decorative CLPL® 0.2mm thick, composed of >2 layers of pure cellulose fibre with a polyurethane finish to protect against humidity, water, scratch, stain, abrasion and UV.

DIMENSIONS

Thicknesses
Panels: 18/25/32mm
Laminate Back: 0.6mm

Width
1200mm

Lengths
2400/3000mm
Other sizes/thickness on application

ABS Edging
100m roll 23/38mm x 1mm
50m roll 38mm x 1mm

Evenex Profiles
Rib 50/20 = 50mm x 20mm x 3600mm
Batten 32/16 = 32mm x 16mm x 3600m
Batten 50/32 = 50mm x 32mm x 3600mm
Other profiles on application

Our unique, patented Evenex manufacturing technology CLPL® offers high technical performance and low polluting impact.

Evenex CLPL® is completely without formaldehyde an provides an excellent barrier from formaldehyde emission from particleboard, MDF, etc. In addition it contains no heavy metals, PVC or melamine and in combustion it does not produce toxic or corrosive gases.

Unlike traditional melamine laminated panels Evenex, being made of wood fibre, can be easily recycled along with the board it is pressed to.

Evenex is available with FSC certification on request. FSC is an internationally recognised body that certifies timber products produced in a sustainable manner, with a stringent traceability system that verifies the path taken by certified raw material throughout all stages of processing, manufacture and distribution.

MATERIAL HANDLING, CARE AND MAINTENANCE

• Evenex is a continuous low-pressure laminate pressed on E0 MRMDF board and stocked in 18mm, 25mm or 32mm x 2400mm & 3000mm x 1200mm panel sizes. Other sizes & substrates are available on request.
• Evenex panels do not have a melamine surface but rather a lacquered surface and therefore lower resistance to surface wear and scratching than standard laminates. The thickness of the face laminate is 0.2mm.
• Treat with special care. DO NOT drag/slide sheets across one another.
• Stack panels onto a flat surface, avoid leaning against walls for a prolonged period to reduce the chance of bowing.
• AVOID applying adhesive tapes to the face & back of the Evenex panels as many contain solvents which will affect the material. Heat and a prolonged period of the tape being on the face can also increase the chance of damaging the surface. Should tape need to be used, refer to the Adhesive Tape Report on TESA 4308 tape which can be found under Downloads.
• Evenex is recommended for vertical and light duty horizontal use only.
• Evenex is not for outdoor use.
• It is recommended that handles or push plates be installed on Evenex faced doors as pressure from repetitive handling may damage surfaces due to abrasion from the transfer of oil, dirt and other materials. Push to open door mechanisms are not recommended without dedicated push plates.
• Finger or hand marks will show less on mid-toned finishes compared to dark toned finishes.
• Clean with a damp, non-abrasive cloth and warm soapy water. DO NOT use harsh chemicals. If you do want to try a chemical, please do so on an off-cut.